Your skimmer can only do its job if the water is at the right height. Too low and it gulps air instead of water; too high and leaves float right past it. It's one of the simplest things to check on a pool, and one of the most common reasons a skimmer stops skimming. This guide covers the right pool water level for your skimmer, what happens when it's off, why it changes, and how to raise or lower it.

The short answer: Keep the water about one-third to one-half of the way up the skimmer opening — around the middle is the usual target. Below about a third, the skimmer can pull in air and starve the pump. Near or above the top of the opening, floating debris passes over the skimmer instead of being pulled in. Check it weekly, and after heavy rain, a long hot stretch, or backwashing.

The Right Pool Water Level for Your Skimmer

The skimmer opening (sometimes called the skimmer mouth or throat) is the rectangular opening in the pool wall at the waterline. Inside it is a floating flap called the weir door. As the pump pulls water in, the weir dips just below the surface so a thin layer of surface water — along with the leaves, bugs, and pollen floating in it — spills over the weir and into the skimmer basket.

That skimming action works best when the water sits roughly in the middle of the opening. At that height:

  • The weir door has room to float and move freely.
  • Surface water flows into the skimmer fast enough to pull floating debris along with it.
  • There's enough water above the bottom of the opening that the skimmer won't draw in air if the level dips a little from evaporation or swimmers getting out.

The same rule applies to inground and above-ground pools, and to vinyl liner, fiberglass, and concrete or gunite pools — it's about the skimmer opening, not the pool type. If your skimmer opening is unusually tall or short, aim for the middle of it.

Pool water sitting around the middle of an inground pool skimmer opening
Around the middle of the skimmer opening is the usual target for pool water level.

What Happens When Pool Water Is Too Low

Low water is the more serious of the two problems because it can affect your equipment, not just how clean the pool looks.

  • The skimmer sucks air. When the waterline drops near the bottom of the opening, the weir door can bottom out and the skimmer starts pulling a mix of air and water. You may hear gurgling or a whirlpool in the skimmer.
  • The pump loses prime. Air in the suction line shows up as bubbles in the pump lid or a pump basket that's only half full of water. Eventually the pump can lose prime entirely.
  • The pump can run dry. A pump running without enough water can overheat and damage its seals and other parts. If the skimmer is your pump's main or only suction, this is the biggest risk.
  • Skimming stops. With little or no water flowing over the weir, floating debris stays on the surface and sinks to the bottom.

If you see these signs, turn off the pump, top the pool up to about the middle of the opening, and re-prime the pump before restarting it. If low water isn't the cause, our guide to a pool skimmer losing suction walks through the other common culprits.

What Happens When Pool Water Is Too High

High water won't usually hurt your equipment, but it does stop the skimmer from skimming well.

  • Debris floats past. When water covers most or all of the opening, the weir can't create that strong surface spill. Leaves and bugs drift by instead of being drawn in, and many end up sinking to the floor.
  • Weak surface flow. The skimmer may still be pulling plenty of water, but from below the surface instead of across it — so the pool looks like the skimmer isn't working.
  • Overflow after storms. Water that's already high can rise over the coping or deck after a heavy rain.

The fix is to lower the water back to about the middle of the opening (see below).

Water levelWhat you'll noticeWhat to do
Below 1/3 of the openingGurgling, air bubbles in the pump lid, weak suction, pump losing primeTurn off the pump, add water, re-prime
1/3 to 1/2 of the openingWeir door floating freely, debris pulled steadily into the skimmerNothing — this is the target range
Near or over the topLeaves floating past the skimmer, poor surface skimmingDrain water down to mid-skimmer

Why Your Pool Water Level Keeps Changing

Some change from week to week is normal. Common reasons the level drops:

  • Evaporation — highest in hot, dry, sunny, and windy weather, and when you run a heater or water features.
  • Splash-out from swimmers, cannonballs, and pool toys.
  • Backwashing or vacuuming to waste, which sends pool water out through the filter's waste line.
  • A leak in the pool shell, liner, skimmer, plumbing, or equipment.

And the main reason it rises: rain, along with sprinklers or downspouts that drain toward the pool.

Losing more water than seems normal? A common way to tell evaporation from a leak is the bucket test: set a bucket on a pool step, fill it to match the pool water level, mark both lines, and compare after a day or two with the pump on its normal schedule. If the pool drops noticeably more than the bucket, you may have a leak. Cracks where the skimmer meets the pool wall or deck are a common spot — if you suspect a leak, have a pool professional take a look.

How to Raise or Lower Your Pool Water Level

To raise the water level

  1. Put a garden hose in the pool (a hose clip on the edge keeps it from falling out).
  2. Fill until the water reaches about the middle of the skimmer opening. Set a timer — an overfilled pool is easy to forget.
  3. If you added a lot of water, test and rebalance your chemistry, since fresh water dilutes chlorine and changes pH and alkalinity.

Some pools have an automatic fill valve, and add-on auto-fill devices are also available. They're convenient, but they can hide a leak, so keep an eye on how much water they add.

To lower the water level

  • Use your filter's waste setting. Many sand and DE filters have a multiport valve with a "Waste" position that sends water out the waste line without filtering it. Follow your filter maker's instructions, and never move the valve while the pump is running.
  • Use a submersible pump with a discharge hose if your filter doesn't have a waste setting.
  • Lower the water a little at a time — stop at the middle of the opening, not below it — and follow any local rules about where pool water can be drained.

Seasonal water level changes

If you keep your pool open year-round, keep the water at mid-skimmer through the winter, too — winter rain can raise it and dry spells can lower it. If you close your pool for the season, the water level is usually lowered below the skimmer as your pool or cover maker recommends. Our pool skimmer winter care guide covers both situations.

Keep the Skimmer Working at the Right Level

Getting the water level right is half the job. The other half is keeping the skimmer from clogging, because a basket packed with leaves starves the pump just like low water does. A few habits help:

  • Check the water level and the skimmer basket at the same time — weekly, and daily during heavy leaf drop or after storms. See how to clean a pool skimmer basket.
  • Make sure the weir door moves freely and isn't stuck up or missing.
  • Stop leaves, twigs, and critters at the skimmer opening before they reach the basket. Our guide to keeping leaves out of your pool skimmer has more ideas.

The Skimmer Shield: Stop Debris at the Skimmer Opening

The Skimmer Shield is a skimmer guard made by B&C Pool Products. It's a flexible, UV-resistant shield with a patented design that bows to fit into the skimmer opening and springs back to lock itself in place — no tools needed, and installation takes under a minute. Its open design is made to let water flow to your pump while it stops leaves, twigs, pine needles, and critters at the skimmer mouth, so they don't pack into the basket.

To clean it, squeeze the wings together, the shield pops out, clear the debris, and pop it back in. It's designed to fit most standard inground and above-ground pool skimmer openings. For the difference between a guard and a skimmer sock, see skimmer guard vs. skimmer sock.

Install the Skimmer Shield for your pool type:

Vinyl liner & fiberglass pool install guide  ·  Concrete & gunite pool install guide  ·  Where to buy

Pool Water Level FAQ

How high should the water be in a pool skimmer?

Keep the water about one-third to one-half of the way up the skimmer opening, with the middle of the opening as the usual target. That gives the weir door room to float and pulls floating debris into the skimmer without letting it draw in air.

What happens if the pool water is below the skimmer?

The skimmer pulls in air instead of water. Air in the suction line can make the pump lose prime, and a pump running without enough water can overheat and be damaged. Turn off the pump, add water to about the middle of the skimmer opening, and re-prime the pump before restarting it.

Can pool water be too high for the skimmer?

Yes. When the water covers most or all of the skimmer opening, the weir door can't create a strong surface flow, so leaves and bugs float past the skimmer instead of being pulled in. Lower the water to about the middle of the opening using your filter's waste setting or a submersible pump.

Should I turn off the pool pump if the water level is low?

If the water has dropped to the bottom of the skimmer opening or the skimmer is gurgling and pulling air, turn the pump off until you've refilled the pool to about mid-skimmer. Running a pump without enough water can damage it.

How can I tell if my pool is leaking or just evaporating?

Try a bucket test: set a bucket on a pool step, fill it to match the pool water level, mark both lines, and compare after a day or two with the pump on its normal schedule. If the pool drops noticeably more than the bucket, you may have a leak and should have a pool professional take a look.

How often should I check my pool water level?

Check it at least once a week, and again after heavy rain, a stretch of hot or windy weather, a pool party, or backwashing. Checking the water level when you empty the skimmer basket makes it an easy habit.

Keep Your Skimmer Clear

Order the Skimmer Shield online from Amazon, Walmart, or eBay and stop leaves and critters at the skimmer opening.